StarTech.com 35S24M2NGFF Manuál s instrukcemi stáhnout pdf (Strana 10)

Instruction Manual

System Installation

1. Open your computer case (refer to the computer case user manual for details), and

place the 35S24M2NGFF with installed M.2 NGFF SSDs into an available 3.5in bay.

2. Using four of the included computer case screws and a Phillip’s head screw driver.

Drive two screws into either side of the 3.5in bay in your computer through the case

mounting holes on the side of the 35S24M2NGFF.

Notes:

• While only four mounting points are required (two on either side), six mounting

holes are available to accommodate dierent styles of computer cases.

• Installation steps may vary depending on your computer case, refer to the

computer case user manual for details.

3. Connect a SATA cable from your motherboard to each of the SATA Data ports on the

35S24M2NGFF (four SATA cables in total).

4. Connect a SATA Power cable from your power supply to the SATA Power Port on the

35S24M2NGFF.

Note: If a SATA power connector is not available, a port replicating SATA Y power

cable is included. Use this cable to connect power to this adapter as well as an

existing peripheral. Check your power supply manual for installation details.

5. Replace the cover on your computer system, and installation is now completed.

1 2 ... 5 6 7 8 9 10 11 12

Žádné komentáře

StarTech.com 35S24M2NGFF Manuál s instrukcemi Strana 10