StarTech.com PEX100SFP Manuál s instrukcemi stáhnout pdf (Strana 6)

Instruction Manual

Connecting to a Network

Note: You must connect the PCI Express Fiber 10/100 Mbps Ethernet Adapter to the

network before installing the network driver.

For connector type, cabling requirements, and maximum segment distance when

connecting the PCI Express 10/100 Mbps Ethernet Adapter to your network, please

refer to the following table.

Speed Connector

Port Speed

Half/Full

Duplex

Cable

Max.

Distance

100BASE-T RJ45 200Mbps

4-pair UTP/

STP Cat. 5

100m

100BASE-FX LC 200Mbps MMF (62.5um) 2km

100BASE-LX10 LC 200Mbps SMF (9, 20um)

550m, up to

10km

1. Install your desired SFP into the SFP slot on the card.

2. Prepare a network cable with corresponding connectors for the two end devices,

one end to the PCI Express Fiber 10/100 Mbps Ethernet Adapter and the other to a

1000Mbps ber port on the network switch.

3. Connect the network cable to the connector on the PCI Express Fiber 10/100 Mbps

Ethernet Adapter. This network cable consists of two individual cables: one for

‘transmission (TX)’, and the other for ‘reception (RX)’.

4. Connect the other end of the network cable to a 1000BASE-SX switch.

5. i. Insert the cable that is connected to the transmit (TX) connector on the PCI

Express Fiber 10/100 Mbps Ethernet Adapter into the receive(RX) connector on the

network switch.

ii. Insert the cable that is connected to the receive (RX) connector on the PCI

Express Fiber 10/100 Mbps Ethernet Adapter into the transmit (TX) connector on

the network switch.

6. When the cable is properly connected to two end devices, turn on the power to

the PC.

7. Check the LNK (Link) LED. The LED will come on when the PCI Express Fiber 10/100 Mbps

Ethernet Adapter is receiving a good link signal from the connected device, a switch.

1 2 3 4 5 6 7 8 9 10

Žádné komentáře

StarTech.com PEX100SFP Manuál s instrukcemi Strana 6